⌕ Поиск по атласу

IETF · RFC · RFC5852

RFC5852 · RSVP-TE Signaling Extension for LSP Handover from the Management Plane to the Control Plane in a GMPLS-Enabled Transport Network

RSVP-TE Signaling Extension for LSP Handover from the Management Plane to the Control Plane in a GMPLS-Enabled Transport Network

In a transport network scenario, Data Plane connections controlled by either a Generalized Multiprotocol Label Switching (GMPLS) Control Plane (Soft Permanent Connections - SPC) or a Management System (Permanent Connections - PC) may independently coexist. The ability of transforming an existing PC into an SPC and vice versa -- without actually affecting Data Plane traffic being carried over it -- is a requirement. The requirements for the conversion between permanent connections and switched connections in a GMPLS Network are defined in RFC 5493. This memo describes an extension to GMPLS Resource Reservation Protocol - Traffic Engineering (RSVP-TE) signaling that enables the transfer of connection ownership between the Management and the Control Planes. Such a transfer is referred to as a Handover. This document defines all Handover-related procedures. This includes the handling of failure conditions and subsequent reversion to original state. A basic premise of the extension is that the Handover procedures must never impact an already established Data Plane connection. [STANDARDS-TRACK]

Официальная английская аннотация

In a transport network scenario, Data Plane connections controlled by either a Generalized Multiprotocol Label Switching (GMPLS) Control Plane (Soft Permanent Connections - SPC) or a Management System (Permanent Connections - PC) may independently coexist. The ability of transforming an existing PC into an SPC and vice versa -- without actually affecting Data Plane traffic being carried over it -- is a requirement. The requirements for the conversion between permanent connections and switched connections in a GMPLS Network are defined in RFC 5493. This memo describes an extension to GMPLS Resource Reservation Protocol - Traffic Engineering (RSVP-TE) signaling that enables the transfer of connection ownership between the Management and the Control Planes. Such a transfer is referred to as a Handover. This document defines all Handover-related procedures. This includes the handling of failure conditions and subsequent reversion to original state. A basic premise of the extension is that the Handover procedures must never impact an already established Data Plane connection. [STANDARDS-TRACK]

Связи документа

Официальный источник · 2010-04-01

Полные импортированные сведения карточки
{
  "id": "RFC5852",
  "number": 5852,
  "title_en": "RSVP-TE Signaling Extension for LSP Handover from the Management Plane to the Control Plane in a GMPLS-Enabled Transport Network",
  "title_ru": "",
  "summary_ru": "",
  "purpose_ru": "",
  "use_ru": "",
  "full_translation_path": "",
  "full_translation_checked_at": "",
  "full_translation_source_sha256": "",
  "architect_note_ru": "",
  "topics_ru": [],
  "translation_state": "not_prepared",
  "verification_level": "not_prepared",
  "verification_level_ru": "Русская выжимка не подготовлена",
  "verification_note_ru": "",
  "abstract_en": "In a transport network scenario, Data Plane connections controlled by either a Generalized Multiprotocol Label Switching (GMPLS) Control Plane (Soft Permanent Connections - SPC) or a Management System (Permanent Connections - PC) may independently coexist. The ability of transforming an existing PC into an SPC and vice versa -- without actually affecting Data Plane traffic being carried over it -- is a requirement. The requirements for the conversion between permanent connections and switched connections in a GMPLS Network are defined in RFC 5493. This memo describes an extension to GMPLS Resource Reservation Protocol - Traffic Engineering (RSVP-TE) signaling that enables the transfer of connection ownership between the Management and the Control Planes. Such a transfer is referred to as a Handover. This document defines all Handover-related procedures. This includes the handling of failure conditions and subsequent reversion to original state. A basic premise of the extension is that the Handover procedures must never impact an already established Data Plane connection. [STANDARDS-TRACK]",
  "authors": [
    "D. Caviglia",
    "D. Ceccarelli",
    "D. Bramanti",
    "D. Li",
    "S. Bardalai"
  ],
  "organizations": [],
  "publication_date": "2010-04-01",
  "current_status": "PROPOSED STANDARD",
  "current_status_ru": "Предлагаемый стандарт",
  "publication_status": "PROPOSED STANDARD",
  "publication_status_ru": "Предлагаемый стандарт",
  "lifecycle": "active",
  "lifecycle_ru": "Действующий",
  "stream": "IETF",
  "stream_ru": "IETF",
  "area": "rtg",
  "area_ru": "Маршрутизация",
  "working_group": "ccamp",
  "source_draft": "draft-ietf-ccamp-pc-spc-rsvpte-ext-07",
  "page_count": 23,
  "doi": "10.17487/RFC5852",
  "keywords": [
    "resource reservation protocol",
    "handover procedures"
  ],
  "formats": [
    "TXT",
    "HTML"
  ],
  "relations": {
    "obsoletes": [],
    "obsoleted_by": [],
    "updates": [],
    "updated_by": [],
    "is_also": [],
    "see_also": []
  },
  "links": {
    "info": "https://www.rfc-editor.org/info/rfc5852/",
    "html": "https://www.rfc-editor.org/rfc/rfc5852.html",
    "txt": "https://www.rfc-editor.org/rfc/rfc5852.txt",
    "datatracker": "https://datatracker.ietf.org/doc/rfc5852/"
  }
}