Опубликованные RFC, связи обновления и замены, официальные статусы и русские переводы.
Реестр · 9 842 документов
Robots Exclusion Protocol
This document specifies and extends the "Robots Exclusion Protocol" method originally defined by Martijn Koster in 1994 for service owners to control how content served by their services may be accessed, if at all, by automatic clients known as crawlers. Specifically, it adds definition language for the protocol, instructions for handling errors, and instructions for caching.
Applicability of the QUIC Transport Protocol
This document discusses the applicability of the QUIC transport protocol, focusing on caveats impacting application protocol development and deployment over QUIC. Its intended audience is designers of application protocol mappings to QUIC and implementors of these application protocols.
Report from the IAB Workshop on Analyzing IETF Data (AID) 2021
The "Show me the numbers: Workshop on Analyzing IETF Data (AID)" workshop was convened by the Internet Architecture Board (IAB) from November 29 to December 2, 2021 and hosted by the IN-SIGHT.it project at the University of Amsterdam; however, it was converted to an online-only event. The workshop was organized into two discussion parts with a hackathon activity in between. This report summarizes …
Vendor-Specific LISP Canonical Address Format (LCAF)
This document describes a new Locator/ID Separation Protocol (LISP) Canonical Address Format (LCAF), the Vendor-Specific LCAF. This LCAF enables organizations to have implementation-specific encodings for LCAF addresses. This document updates RFC 8060.
Locator/ID Separation Protocol (LISP) Generic Protocol Extension
This document describes extensions to the Locator/ID Separation Protocol (LISP) data plane, via changes to the LISP header, to support multiprotocol encapsulation and allow the introduction of new protocol capabilities.
Locator/ID Separation Protocol (LISP): Shared Extension Message and IANA Registry for Packet Type Allocations
This document specifies a Locator/ID Separation Protocol (LISP) shared message type for defining future extensions and conducting experiments without consuming a LISP Packet Type codepoint for each extension. This document obsoletes RFC 8113.
Locator/ID Separation Protocol Security (LISP-SEC)
This memo specifies Locator/ID Separation Protocol Security (LISP-SEC), a set of security mechanisms that provides origin authentication, integrity, and anti-replay protection to the LISP's Endpoint-ID-to-Routing-Locator (EID-to-RLOC) mapping data conveyed via the mapping lookup process. LISP-SEC also enables verification of authorization on EID-Prefix claims in Map-Reply messages.
Locator/ID Separation Protocol (LISP) Map-Versioning
This document describes the Locator/ID Separation Protocol (LISP) Map-Versioning mechanism, which provides in-packet information about Endpoint-ID-to-Routing-Locator (EID-to-RLOC) mappings used to encapsulate LISP data packets. This approach is based on associating a version number to EID-to-RLOC mappings and transporting such a version number in the LISP-specific header of LISP-encapsulated packe…
Locator/ID Separation Protocol (LISP) Control Plane
This document describes the control plane and Mapping Service for the Locator/ID Separation Protocol (LISP), implemented by two types of LISP-speaking devices -- the LISP Map-Resolver and LISP Map-Server -- that provide a simplified "front end" for one or more Endpoint IDs (EIDs) to Routing Locator mapping databases. By using this control plane service interface and communicating with Map-Resolver…
The Locator/ID Separation Protocol (LISP)
This document describes the data plane protocol for the Locator/ID Separation Protocol (LISP). LISP defines two namespaces: Endpoint Identifiers (EIDs), which identify end hosts; and Routing Locators (RLOCs), which identify network attachment points. With this, LISP effectively separates control from data and allows routers to create overlay networks. LISP-capable routers exchange encapsulated pac…
An Architectural Introduction to the Locator/ID Separation Protocol (LISP)
This document describes the architecture of the Locator/ID Separation Protocol (LISP), making it easier to read the rest of the LISP specifications and providing a basis for discussion about the details of the LISP protocols. This document is used for introductory purposes; more details can be found in the protocol specifications, RFCs 9300 and 9301.
Proxying UDP in HTTP
This document describes how to proxy UDP in HTTP, similar to how the HTTP CONNECT method allows proxying TCP in HTTP. More specifically, this document defines a protocol that allows an HTTP client to create a tunnel for UDP communications through an HTTP server that acts as a proxy.
HTTP Datagrams and the Capsule Protocol
This document describes HTTP Datagrams, a convention for conveying multiplexed, potentially unreliable datagrams inside an HTTP connection. In HTTP/3, HTTP Datagrams can be sent unreliably using the QUIC DATAGRAM extension. When the QUIC DATAGRAM frame is unavailable or undesirable, HTTP Datagrams can be sent using the Capsule Protocol, which is a more general convention for conveying data in HTTP…
ifStackTable for the Point-to-Point (P2P) Interface over a LAN Type: Definition and Examples
RFC 5309 defines the Point-to-Point (P2P) circuit type, one of the two circuit types used in the link-state routing protocols, and highlights that it is important to identify the correct circuit type when forming adjacencies, flooding link-state database packets, and monitoring the link state. This document provides advice about the ifStack for the P2P interface over a LAN Type to facilitate opera…
Clarifications for Ed25519, Ed448, X25519, and X448 Algorithm Identifiers
This document updates RFC 8410 to clarify existing semantics, and specify missing semantics, for key usage bits when used in certificates that support the Ed25519, Ed448, X25519, and X448 Elliptic Curve Cryptography algorithms.
Application-Specific Link Attributes Advertisement Using the Border Gateway Protocol - Link State (BGP-LS)
Extensions have been defined for link-state routing protocols that enable distribution of application-specific link attributes for existing as well as newer applications such as Segment Routing (SR). This document defines extensions to the Border Gateway Protocol - Link State (BGP-LS) to enable the advertisement of these application-specific attributes as a part of the topology information from th…
Transmission Control Protocol (TCP)
Современная основная спецификация TCP, объединяющая и заменяющая исходный RFC 793 и накопленные обязательные исправления. Определяет надёжный упорядоченный байтовый поток, состояния соединения и базовые правила обработки сегментов.
Binary Representation of HTTP Messages
This document defines a binary format for representing HTTP messages.
A YANG Network Data Model for Layer 2 VPNs
This document defines an L2VPN Network Model (L2NM) that can be used to manage the provisioning of Layer 2 Virtual Private Network (L2VPN) services within a network (e.g., a service provider network). The L2NM complements the L2VPN Service Model (L2SM) by providing a network-centric view of the service that is internal to a service provider. The L2NM is particularly meant to be used by a network c…
Concise Problem Details for Constrained Application Protocol (CoAP) APIs
This document defines a concise "problem detail" as a way to carry machine-readable details of errors in a Representational State Transfer (REST) response to avoid the need to define new error response formats for REST APIs for constrained environments. The format is inspired by, but intended to be more concise than, the problem details for HTTP APIs defined in RFC 7807.
Towards Remote Procedure Call Encryption by Default
This document describes a mechanism that, through the use of opportunistic Transport Layer Security (TLS), enables encryption of Remote Procedure Call (RPC) transactions while they are in transit. The proposed mechanism interoperates with Open Network Computing (ONC) RPC implementations that do not support it. This document updates RFC 5531.
Recommendations on the Filtering of IPv6 Packets Containing IPv6 Extension Headers at Transit Routers
This document analyzes the security implications of IPv6 Extension Headers and associated IPv6 options. Additionally, it discusses the operational and interoperability implications of discarding packets based on the IPv6 Extension Headers and IPv6 options they contain. Finally, it provides advice on the filtering of such IPv6 packets at transit routers for traffic not directed to them, for those c…
Greasing the QUIC Bit
This document describes a method for negotiating the ability to send an arbitrary value for the second-most significant bit in QUIC packets.
Manifests for the Resource Public Key Infrastructure (RPKI)
This document defines a "manifest" for use in the Resource Public Key Infrastructure (RPKI). A manifest is a signed object (file) that contains a listing of all the signed objects (files) in the repository publication point (directory) associated with an authority responsible for publishing in the repository. For each certificate, Certificate Revocation List (CRL), or other type of signed objects …
The Base45 Data Encoding
This document describes the Base45 encoding scheme, which is built upon the Base64, Base32, and Base16 encoding schemes.
Multihoming Deployment Considerations for DDoS Open Threat Signaling (DOTS)
This document discusses multihoming considerations for DDoS Open Threat Signaling (DOTS). The goal is to provide some guidance for DOTS clients and client-domain DOTS gateways when multihomed.
IAB Charter Update for RFC Editor Model
This document updates the IAB Charter (RFC 2850) to be consistent with version 3 of the RFC Editor Model (RFC 9280).
Responsibility Change for the RFC Series
In RFC 9280, responsibility for the RFC Series moved to the RFC Series Working Group and the RFC Series Approval Board. It is no longer the responsibility of the RFC Editor, and the role of the IAB in the RFC Series is altered. Accordingly, in Section 2.1 of RFC 2026, the sentence "RFC publication is the direct responsibility of the RFC Editor, under the general direction of the IAB" is deleted.
Entities Involved in the IETF Standards Process
This document describes the individuals and organizations involved in the IETF standards process, as described in BCP 9. It includes brief descriptions of the entities involved and the role they play in the standards process. The IETF and its structure have undergone many changes since RFC 2028 was published in 1996. This document reflects the changed organizational structure of the IETF and obsol…
RFC Editor Model (Version 3)
This document specifies version 3 of the RFC Editor Model. The model defines two high-level tasks related to the RFC Series. First, policy definition is the joint responsibility of the RFC Series Working Group (RSWG), which produces policy proposals, and the RFC Series Approval Board (RSAB), which approves such proposals. Second, policy implementation is primarily the responsibility of the RFC Pro…